Cisco 210-065 Cisco Certified Network Associate Collaboration certification exam as a profession has an extraordinary evolution over the last few years. Cisco Certified Network Associate Collaboration 210-065 exam is the forerunner in validating credentials against. Here are updated Cisco 210-065 exam questions, which will help you to test the quality features of DumpsSchool exam preparation material completely free. You can purchase the full product once you are satisfied with the product.

Vendor: Cisco
Certifications: Cisco Certified Network Associate Collaboration
Exam Name: Implementing Cisco Video Network Devices
Exam Code: 210-065
Total Questions: 331

♥ 2018 Valid 210-065 Exam Questions ♥

210-065 exam questions, 210-065 PDF dumps; 210-065 exam dumps:: https://www.dumpsschool.com/210-065-exam-dumps.html (331 Q&A) (New Questions Are 100% Available! Also Free Practice Test Software!)

Latest and Most Accurate Cisco 210-065 Dumps Exam Questions and Answers:

Question: 46

Which option describes a difference between EIGRP for IPv4 and IPv6?

A. Only EIGRP for IPv6 advertises all connected networks.
B. Only EIGRP for IPv6 requires a router ID to be configured under the routing process-
C. AS numbers are configured in EIGRP but not in EIGRPv3.
D. Only EIGRP for IPv6 is enabled in the global configuration mode.

Answer: B

Router ID – Both EIGRP for IPv4 and EIGRP for IPv6 use a 32-bit number for the EIGRP router ID. The 32-bit router ID is represented in dotted-decimal notation and is commonly referred to as an IPv4 address. If the EIGRP for IPv6 router has not been configured with an IPv4 address, the eigrp router-id command must be used to configure a 32-bit router ID. The process for determining the router ID is the same for both EIGRP for IPv4 and IPv6.

Question: 47

Which component of the Cisco SDN solution serves as the centralized management system?

A. Cisco OpenDaylight
B. Cisco ACI
C. Cisco APIC
D. Cisco IWAN

Answer: B

Cisco ACI is a comprehensive SDN architecture. This policy-based automation solution supports a business-relevant application policy language, greater scalability through a distributed enforcement system, and greater network visibility. These benefits are achieved through the integration of physical and virtual environments under one policy model for networks, servers, storage, services, and security.

Question: 48

Which statement about DTP is true?

A. It uses the native VLAN.
B. It negotiates a trunk link after VTP has been configured.
C. It uses desirable mode by default.
D. It sends data on VLAN 1.

Answer: A

Question: 49

Refer to the exhibit.

While troubleshooting a switch, you executed the show interface port-channel 1 etherchannel command and it returned this output. Which information is provided by the Load value?

A. the percentage of use of the link
B. the preference of the link
C. the session count of the link
D. the number source-destination pairs on the link

Answer: D

Question: 50

Which IEEE standard does PVST+ use to tunnel information?

A. 802.1x
B. 802 1q
C. 802.1w
D. 802.1s

Answer: B

New Updated 210-065 Exam Questions 210-065 PDF dumps 210-065 practice exam dumps: https://www.dumpsschool.com/210-065-exam-dumps.html

         

Facebook Comments